Model W1790
3
⁄
8" Reversible Air Drill
Instruction Sheet
EYE INJURY HAZARD!
Always wear safety glasses during
use to prevent serious personal
injury!
INJURY HAZARD!
Always disconnect tool from air to
prevent unexpected operation dur-
ing service!
Figure 1. Model W1790.
INJURY HAZARD!
Never exceed 120 PSI!
Quick
Connector
Quick
Connector
Lubricator
Regulator
Specifications
Your
Tool
Drive Size..................................................................3⁄8
"
Air
Compressor
No Load Speed..................................................1800 RPM
Average Air Consumption...............................................6
CFM Required PSI...................................................90 PSI
Quick
Coupler
Quick
Coupler
Air Hose
Filter
1
Air Inlet...............................................................⁄4" NPT
Inventory
Figure 2. Installing your tool.
A. Air Drill........................................................................1
1
B.
⁄4" NPT Quick Connect Fitting (male)........................1
C. Chuck Key..................................................................1
Lubrication
Lubricate your air drill with pneumatic tool oil. If you do
not have a lubricator installed in your air line, place one
drop of pneumatic tool oil into the air fitting daily, as
shown in Figure 2.
Figure 3. Lubricating directly into air
fitting.
COPYRIGHT © JUNE, 2007 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in China
#9580JM
|