Top Load Washer
PRODUCT MODEL NUMBERS
RECESSED AREA OR CLOSET INSTALLATION
For closet installation, with a door, the minimum ventilation openings in the top and
bottom of the door are required (view C). Louvered doors with equivalent air ventilation
openings are acceptable.
MTW6200V, WTW6500W, WTW6800W
WTW6300W, WTW6340W
*
3
"
14"*max
(76 mm)
Electrical: A 120 volt, 60 Hz., AC only,
2*
(356 mm)
15- or 20-amp, fused electrical supply is required.
A time-delay fuse or circuit breaker is recommended.
It is recommended that a separate circuit serving
only this appliance be provided.
48"
(310 cm2)
17"*
(431.8 mm)
2*
24
"
*
3
"
(155 cm2)
(76 mm)
1
1"
2
1"
1"*
27"
5"
27 / "
(25 mm)
(25 mm)(686 mm)
(127 mm)
(699 mm)
A
B
C
Front view
Side view
Closet door with vents
* Required Spacing
DRAIN SYSTEM OPTIONS
Standpipe drain system - wall or floor (view A & B)
The standpipe drain requires a minimum diameter standpipe of
2" (51 mm). The minimum carry-away capacity can be no less
than 17 gal. (64 L) per minute.
Laundry tub drain system (view C)
The laundry tub needs a minimum
20 gal. (76 L) capacity. The top of the
laundry tub must be at least 39"
(990 mm) above the floor and no
higher than 96" (2.4 m) from the
bottom of the washer.
Floor drain system (view D)
The floor drain system requires a siphon
break that may be purchased separately.
The siphon break must be a minimum of
28" (710 mm) from the bottom of the
washer. Additional hoses might be
needed.
The top of the standpipe must be at least 39" (990 mm) high
and no higher than 96" (2.4 m) from the bottom of the washer.
39"
28"
39"
(990 mm)
(990 mm)
(710 mm)
C
D
A
B
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10240438B
09/2009
|